|
I’m trying to figure out how to pin or wire in other sensors that aren’t in our harness. I have a boost solenoid and flex fuel sensor. You would think there would be a tutorial or video somewhere on the internet, but I haven’t found anything. There will be a wiring diagram, but it would be nice to have a visual than just a schematic.
On the boost solenoid, the solenoid can be set up to bleed off boost pressure from opening the diaphragm until target boost is reached, or it can be set up to pressurize the top of the wastegate to resist the diaphragm from opening until target boost is reached. Seems like wiring could be different or maybe wiring could be the same, but the software runs the solenoid differently based on the setup parameters. I don’t know.
|