Well here’s the conclusion to my thread, one way or another I’ve got my Aero front and I’m pretty satisfied with it.
Although I might need side skirts because of how low my front end sits now.
Installation was pretty easy, didn’t buy any hardware just reused the bolts and push clips from the original front bumper. You need specific push clips for the 3 wheel well holes as the ones I had weren’t long enough to push through the 3 layers (bumper, wheel well plastic, aero piece) The pull tabs from the 3m tape were very flimsy though
Putting my splitter back on was the hardest part as the aero front extends down below the bumper slightly, so you can’t have the splitter sitting flush with the front bumper. My bolts were also too short so I had to find really long ones
