Quote:
Originally Posted by 86TOYO2k17
WMI is a tried and true god send for IATs and heat soak.
Killer Chiller does wonders for IATs as well.
Larger HE will help a bit as well
Lots of options.
Not sure how much people on this platform with the sprintex 210 have done beyond the standard IC setup.
One user did make a full jacket for the SC unit that seemed to help but that was a one off.
I had WMI and it did wonders for IATs/heatsoak.
Air to Water HE/IC setups are common practice, principles that work and apply to any platform will work and apply to this.
Killer Chiller can make intercoolers frost over they get so cold.
You would need to figure out your own mounting solution but frozen boost has larger HE that would be easy to incorporate.
you could also get a larger reservoir and/or relocate it. larger capacity prolongs heat seek and moving the reservoir further from the engine / SC unit will prevent reservoir heat soaking removing one source of heat.
So many options.
Not many that people on this platform have done, but all have been done by many on other platforms and are proven to work.
You'll have to figure out your own solutions for this platform if you want to take it beyond the typical setup.
|
And do you have pictures or something to explain how you tapped the map sprintex plate?