[FR-S2GT86]

Got the edge trim put on and the fuse shelf installed and the fuse holder secured in place with some stainless steel machine screws and nuts. Connected the main 4-gauge power wire from the positive terminal to the rear lug and then ran the rest of the wire into the car through a grommet in the firewall.







Here is a picture with the battery terminal cover in place and the fuse holder cover in place,



I think what I'll do next is drill a hole in the top of the shelf a few inches in front of the fuse holder and run the power wire straight down through a grommet. That should give it a cleaner look than having it routed over the edge of the shelf back towards the positive terminal.