[ACT86]

Looking to pull the pin on a set of wheels in the near future. I’ve pretty much read this whole thread and the millions of pics in associated threads. Love the meaty tyre thread and the thread containing all wheel fitment - awesome resources for newbies.

Just thought it best to triple check fitment here to be safe. Ive had relatively flush fitment on my cars in the past (current below), but given the 86 is my daily I’m looking for something that adds a bit of width, but won’t cause any scrubbing issues when pushing. I’ve come up with the below, which (hopefully) will fill out the guards nicely, but not give too much poke.

18x9 ET45-47 (front)
18x9 ET38 (rear)
245/35/18s

I’m looking to lower on coilovers (likely ST based on advice here given they’re well priced and appear to be relatively comfortable) at the time of fitting wheels, or shortly after.

I believe the front may have trouble clearing the front spring before I fit coilovers. Will the above width / offset avoid notable poke once lowered (25-30mm)?