Quote:
Originally Posted by pro_turbo
please someone help me to understand the secondary fuel injector table on the ecuflash or ecutek or romraider
by 0.3 is this means 30% secondary and 70% primary
thanks
|
I think the tables your refering to are the port to direct injection ratio tables.
There are three cold warm and hot. Its best to keep same values in all 3 tables
The value in the table is the amount of port injection sometimes its a value between 0 and 1 and sometimes it might be a percent depending on which definitions your using.
so if tavle has 0.3 or 30% it means at that load rpm point ecu will use 30% port and 70% direct injection
Best nevercto put 1 or 100% in the tables as that means all port injection. This means no fuel through the direct injectprs which are in combustion chamber of engine. That would likely cause direct injectors seals to overheat and get damaged. You probably want not to go over say 0.7 to 0.8 or 70 to 80 % port injection so your always runnog a good amount of fuel through the direct injectprs