Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Racer X Intake manifold design, development, and results

captain awesome · 03-01-2021, 01:29 PM

Adding this to the original post from the dyno, but our method of testing was as follows:

I ran 4 pulls and shut the car down to heat soak. 4 more pulls and this is the best run out of the 8. All were consistent in power however.

I then swapped back to the stock intake while still strapped to the dyno, flashed the tune, and proceeded to run 8 more pulls just like we did with the Racer X. We tried to remove as many variables as possible.

03-01-2021, 01:29 PM	#248
captain awesome Wears Pants Join Date: Apr 2019 Drives: 14 FRS K24 swap - SOLD Location: Bella Vista, AR Posts: 559 Thanks: 383 Thanked 449 Times in 274 Posts Mentioned: 6 Post(s) Tagged: 0 Thread(s)	Adding this to the original post from the dyno, but our method of testing was as follows: I ran 4 pulls and shut the car down to heat soak. 4 more pulls and this is the best run out of the 8. All were consistent in power however. I then swapped back to the stock intake while still strapped to the dyno, flashed the tune, and proceeded to run 8 more pulls just like we did with the Racer X. We tried to remove as many variables as possible.