Quote:
Originally Posted by BrahmaBull1990
Great reply, thank you.
I am seeing the Tomei front pipe is 60.5mm (2.38189"). That seems pretty negligible of a change over the stock 2.118".
Was it difficult to get your OEM overpipe out?
|
The overpipe and the old aftermarket header were on there when I bought it. The old header was trash so I got a Tomei UEL. I cleaned all mating surfaces (collector flange and block side with one of those green scrub pads - new) and with the Tomei gaskets, i had ZERO issues mating up to the DC sports overpipe that was already there, nice and tight fitment but minor manipulation to get it and the gasket and header set to the overpipe.. My exhaust wrap went two layers at the flanges but even then i was able to get an open wrench on the nut side and my torque wrench on the bolt (rear) side and tighten every thing down easily.. FWIW, i used a crows foot 14 and an extension to get the one bolt on the drivers side block flange.. super easy install. but yea i measured them both before i put the new header on.