[Btborja]

Hello everyone purchased a 2013 Scion FR-S AUTOMATIC recently. It had a spun bearing. I disassembled the engine and turned out crank was bad also. Ended up putting new crank bearings etc. Everything oem spec no modifications. The engine cranks but won’t start. I’ve compression checked all cylinders (all right at 150psi) I’ve checked for spark on each coil and spark plug, all checks out. Originally when I first assembled everything I had the direct injector rail off. when reinstalling rail didn’t have all seals on it so injectors leaked(one sign I knew my cylinders were getting fuel) That and all my spark plugs were wet when I pulled them to inspect . Obviously I put all brand new seals and no leak now. I’ve checked the crank positioning sensor and it works. 110% sure I’ve installed the timing chain correctly and have everything lined up correctly. Ive been reading into all types of forums and different situations. I installed trigger plate correctly so can rule that out. The car is throwing no codes except p1604 which is startability malfunction. Obviously throwing that cause car won’t start haha I’m at the point I’m just trying to figure out where else to check. Any advice anyone?? Before anyone asks yes I’ve checked all fuses, I’ve checked battery voltage, had my truck hooked up to to jump it. Starter fluid the whole 9. Just kind of stumped. I wanna take it to a dealer but hell as deep as I’ve looked into the car I’m afraid my diagnostic bill will be insane. I will see if I can post video of the crank onto this post. I’m new to forums so I really don’t know how to work this haha anyways, any advice will be helpful.