Finished up the PDM wiring this weekend. PDM is controlling the radiator fans, motec ECU, coils, lambda controllers, and reverse lockout solenoid. Some sensors, gps module, and dash control buttons wired into it as well. It’s also taking data from two can buses. On the CAN1 bus I have the Motec and the factory Subaru bus. On CAN2 I have the two AEM lambda controllers and MSEL battery relay. Will be adding the Aim RIO02 module to that bus too when it’s finally released.
Really happy with how the dash looks assembled.
Still need to wire the fuel level sensor, mount the gps antenna, and figure out the can messages for some of the dash indicators. Half tempted to just take those in as analog signals though. Was trying to learn how to sniff can messages but I didn’t get very far.
If you look closely you can see the M130 peaking through. Ethernet connection is for the ECU.
