Quote:
Originally Posted by aseylys
I bought the car with roughly ~3k miles, and everything was stock (per the dealer).
The battery is brand new too, so it's reading 12.58V and just for good measure I've got it hooked up to the charger that's giving it 12V/6A.
BRZ is selected under the Car Select menu after every time I reopen ECUFlash.
I bent the pins inward for good measure, but I know my OBD port is good because before throwing on the Tactrix I had an OBDII BT thingy that worked great.
I even got another chord (1ft long) to try.
And at the end of all this tinkering, I'm still receiving the exact same error message in the log.
Hopefully we figure this out.
|
can you try READ on a friends car ??
also try removing battery termial for few minutes reconnect then try read with tactrix before you start car
if you have a micro sd car less than 8 gb put the logcfg.txt in the root directory as per my tactrix post see if you get ant log data. if tactrix logs data ok then connection to ecu ok note dont have usb cable plugged in when logging it only logs in standalone mode.
if it logs but wont read ECU then it very likely locked by tune