Quote:
Originally Posted by golemslord
Hi all, installed valenti tail lights at first with just a 8mm socket and hand tightening the screws (the best of my ability). Next day there seems to be a tiny bit of water at the bottom of the tail light but no condensation (due to heavy rain).
Following day, I then used a 1/4 drive ratchet and 8mm socket to tighten all screws. (all with a little less than a quarter turn)
My question is if that is too tight or just right or too less? I know it is suppose to be 39in.lbs or 4.5nm or 3.25ft.lbs but no idea what it feels like
Lights are purchased used but previous owner bought new 3 months ago
Thank you
|
Are the gaskets the ones that came from the factory (ie. the ones previous owner used)? If so, you need to get a new set of gaskets. They get pressed the first time you tighten the bolts on install, and seal successfully. After that, the gasket retains the shape and is useless for next install. In other words, they are non-reusable and must be replaced each install.
Torque is 4.5 n-m or 3.3 ft-lbf (not tight at all). Still suggest a torque wrench but most importantly new gaskets.