So here are the settings I'm going with for this new Omni MAP sensor for the time being. Changes from the first round are highlighted in yellow. The values for
A, B, C and
E should be exact, and I've decided to temporarily leave the values for
D and
F at the OEM defaults for now (circled in red) and see how that operates in naturally aspirated configuration. I'll change them later if I decide I need to or simply untick the P0068 from the DTC map. However, I highly doubt there will be an issue until I am boosted. I'll cross that bridge when I burn it.:
A) MAP Sensor Scaling - Pressure Offset = 0.1000 bar
B) MAP Sensor Scaling - Voltage Multiplier = 0.4902 bar/volt
C) MAP Sensor Voltage Max (for the DTC P0108 to activate) = 4.966 volts
D) P0068 MAP Sensor Voltage Maximum (for the DTC P0068 to activate) = 3.30 volts
E) MAP Sensor Voltage Min (for the DTC P0107 to activate) = 0.133 volts
F) P0069 MAP Sensor Voltage Minimum (for the DTC P0069 to activate) = 1.25 volts
Thank you @
Kodename47 for your generosity and teaching skills.