|
Hooked up the mityvac bleeder and had tons of issues. Would not maintain a vacuum when connected to the bleeder. Leaks through the flare fittings. Did not see any leaks at first then saw little weepage from the lines I had made. I took out all the lines I made and I am redoing my setup. Making sure all the flares are good to go and will test the flares I make with the vacuum bleeder. I am using stainless lines and the flares are a little harder to make due to the hardness. Going to change a few things such as a banjo on the front of the master cylinder. Also discovered the proportioning valve was stuck all the way closed so nothing was getting to the rear brakes.
|