[kurty85]

Having a terrible time bleeding the system. The reservoir is full, all connections are tight and verified no leaks. I removed the master cylinder to verify it is not sticking internally. It is working as I push in the piston with my hand and fluid shoots out of the fitting at the front. I reinstalled the master cylinder, checked all connections again, had my son pushing on the pedal while I checked each corner. No fluid comes out of any caliper at any corner. I have also adjusted the brake bias adjuster all the way in and out and make no difference. Only thing I could possibly think of is that the front is higher than the rear, but that should not matter. Can anyone think of anything that might cause this. Also, when I pump faster with the brake pedal, the fluid in the reservoir shoots up radidly and eventually comes out the vent in the cap. Last thing I also did was swap the bleeders on the front brakes from the bottom to the top. Still made no difference.