Hi all,
Disclaimer: Before I start, let me just say I've spent several hours browsing the forums, watching several YouTube videos before I couldn't find the answers to my questions. I've read RickyBobby's
https://www.ft86club.com/forums/show...5&postcount=20 post, and while it was great and very informative, due to the fact that he has a different camera (and therefore different wiring) I wasn't able to find much support for my case.
I bought a backup camera from eBay and a wiring harness from autoharnesshouse as opposed to the one that everyone usually seems to get; the EviSystems backup camera kit. I've seen other cameras used like the Rydeen Duo but unfortunately even that camera comes with the single convenient black wire unlike mine :/
Problem:
1) The backup camera from eBay comes with a negative and positive wire as opposed to a single 'plug'; I have no idea where the negative wire goes to. This is the link to my camera,
http://www.ebay.ca/itm/254659666790
In the ad link, you can see their wiring diagram and the positive and negative wires split off from the black cable. Again, I have no idea where this goes or attaches to.
2) The camera also comes with that super long wire with two yellow connectors that you're supposed to run along the car (from trunk to HU); there's two short red wires coming out of each connector that I also have no idea of where it goes.
3) The autoharnesshouse wiring harness also comes with this relay that no ones seems to have covered? Where do I install it, why are there no screws to install it with, do I just let it hang? etc.
This is my first post so I apologize if I've posted this in the wrong section or if this has been covered before (I genuinely have been searching for hours and cannot find an answer or someone with a similar experience to mine).
Thanks in advance for stopping by!