Quote:
Originally Posted by Sam86
Would you think it'd look weird with the grill piece on its own? is the gap something that could just be filled in, and then cut off those little tabs on the sides I can see in the diagram where the screws go?
a picture of it disassembled would be great because I don't know that i've seen anyone post it before it was attached
|
Honestly, it's not worth modifying the middle section. You would have to chop it into two pieces (the bottom side of it extends past the bottom of the bumper by ~1-2 inches) and filling the huge gap on both sides will be a pain. The tabs are for the OEM bumper mounting points minus the two tabs for the side pieces (which is inside and does not stick out).
If I have time, I can try grab some pictures for you.