View Single Post
Old 07-24-2020, 02:01 PM   #7
congee
Senior Member
 
congee's Avatar
 
Join Date: Jul 2013
Drives: SSM BRZ
Location: Canada
Posts: 545
Thanks: 218
Thanked 150 Times in 86 Posts
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quote:
Originally Posted by radroach View Post
@congee did you read both sides of the dipstick? One side always reads high. Flip it over, the other side will read much lower. How I know this? Well I pulled my dipstick after an oil change and it read high just like that, drove to mechanic on the corner and he laughed and told me to flip the dipstick over, it read perfectly between the lines, at the full mark. I think he's dealt with enough Subaru's to know this.

I've had leaks from the oil filter before. Somehow wasn't tightened down right one time. Sprayed my whole engine bay with oil and left nice little drops all over the driveway.
Thank you, didnt know this either haha

So I checked in the morning when it was cold, and again after it was warmed up(waited 5 mins after turning the car off). checked the lowered side and it still read about an inch over the full mark.

Oddly enough, the burning smell was gone after I tightened the oil filter a bit and wiped away some oil coming out of the dipstick tube.

Should I try to siphon some of the oil out or would it be safe to drive for another week when I can go back to my dealer
__________________
congee is offline   Reply With Quote
The Following User Says Thank You to congee For This Useful Post:
humfrz (07-24-2020)