Supercharger bolts backed out after the install of my Track Pack... This happens to be the second time it's happened. Found out the threads are stripped-and I know that I had torqued down to 10ft/lb per screw, so I figure that the previous owner ughalugged it or something. I repaired the threads with Time-Serts, hoping that it'll hold and get it back to factory strength. and it seems pretty good now that its mounted with new screws, two of which just look a bit different, strangely enough.
The pulley bounced around and got lodged against the A/C compressor pulley and left me stranded. So it's got some wear and shavings all over. I did purchase the high boost pulley, since thats the only part that's available as a replacement part on the website and was tempted to put that in and mount it, but I don't really know if I need injectors and a fuel pump to run that on an otherwise stock motor.
The first time, the belt was good. This time, the belt ended up getting stretched hardcore.
So with that, I need a replacement 30mm belt-- any idea on the specs or a part number from Gates? I saw the first post with the 20mm, and then someone posted a 30mm link from eBay with a TP1280, and I think the first one was a 20mm TP1200... but I'm not sure how the original pulleys are compared to the 2nd version and then the Track pack. My 20mm kit pulleys seems to be the same size as the 30 mm kit, but skinnier-- and if my kit is not the original version, then I'm thinking that a TP1200 30mm would be the one to use.... right?
Any thoughts or insight?