View Single Post
Old 06-07-2020, 02:41 PM   #328
BRZ_Mobin17
Member
 
Join Date: Nov 2019
Drives: 2017 Subaru BRZ (silver)
Location: Pomona
Posts: 31
Thanks: 0
Thanked 3 Times in 3 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Hello 86 club.
So, currently my BRZ is running E85 with OFT and I have almost everything I need to finally install my Vortech I’ve had laying around for months now. I’ve just been debating what pulley I want to go with and I read someone mentioned the 3”, but it’s an 8rib.
How much of an issue would this be? And if it is a safe possibility what size belt should I run?
Also I’m going to be re-scaling the front O2, will I need to do this with the Omni 3 I’m going to be installing? And any other recommendations you might have?
Thank you for your time!

An idea of my setup:
*Engine*
- Vortech V3(not installed)
- OFT v2 (E85 pop tune)
- Omni 3Bar Map(not installed)
- Radium dual catch cans
- FIC 650 injectors(not installed)
- AEM 340 fuel pump(Not installed)
*Exhaust*
- Speed Factory UEL headers
- HKS front pipe
- Tomei over pipe
- Greddy Evo cat-back
*Wheel/Suspension*
- Tein Flex-A
- Rayz Gram Lights (57extreme)

Last edited by BRZ_Mobin17; 06-07-2020 at 10:48 PM.
BRZ_Mobin17 is offline   Reply With Quote