Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Having a ton of trouble removing reverse lockout.

norcalpb · 05-20-2020, 07:52 PM

Hello,

I am looking to install a Raceseng reverse lockout but I cannot get the damn pin out. I started with a 3/32 Allen wrench which didn’t work. I think bought the proper punch and even that is not working!

I have hammered the screw enough where it is almost pushed in towards the middle of the shifter, but the other side of the pin is not moving at all. Is it bending maybe?

Either way I feel like at this point I’m doing damage to the transmission, but I was seeing if my next step is to drill or any other insight you guys had.

TIA

05-20-2020, 07:52 PM	#1
norcalpb Senior Member Join Date: Oct 2013 Drives: 2013 BRZ, 2023 Model 3 Location: SF Bay Area Posts: 2,345 Thanks: 1,256 Thanked 902 Times in 590 Posts Mentioned: 15 Post(s) Tagged: 0 Thread(s)	Having a ton of trouble removing reverse lockout. Hello, I am looking to install a Raceseng reverse lockout but I cannot get the damn pin out. I started with a 3/32 Allen wrench which didn’t work. I think bought the proper punch and even that is not working! I have hammered the screw enough where it is almost pushed in towards the middle of the shifter, but the other side of the pin is not moving at all. Is it bending maybe? Either way I feel like at this point I’m doing damage to the transmission, but I was seeing if my next step is to drill or any other insight you guys had. TIA