Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

lazerking117 · 05-17-2020, 02:10 PM

I bough my 2013 Subaru BRZ used and the last owner had a harness bar installed. The original front left hand and right hand seat belts were not removed, but the top bolts were undone and the seatbelt was wound up and tucked behind the b pillar. The guy said that it turned on once he installed the harness bar. I removed it and rebolted the seat belts.

I’m getting a B1900 code when I use my OBD2/SRS scanner, I can delete the code, but it comes back on once the car is reset.

The code says that it is a Short In Front Driver Side Pretensioner Squib Circuit.

Has anyone else encountered this problem? And also is this a “hard code” on my SRS module that I would have to send in to reset?

05-17-2020, 02:10 PM	#1
lazerking117 Member Join Date: May 2019 Drives: Black 2013 Subaru BRZ Limited Location: USA Posts: 12 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	SRS light on the dash, need help! I bough my 2013 Subaru BRZ used and the last owner had a harness bar installed. The original front left hand and right hand seat belts were not removed, but the top bolts were undone and the seatbelt was wound up and tucked behind the b pillar. The guy said that it turned on once he installed the harness bar. I removed it and rebolted the seat belts. I’m getting a B1900 code when I use my OBD2/SRS scanner, I can delete the code, but it comes back on once the car is reset. The code says that it is a Short In Front Driver Side Pretensioner Squib Circuit. Has anyone else encountered this problem? And also is this a “hard code” on my SRS module that I would have to send in to reset?