Quote:
Originally Posted by CSG Mike
There's not an overabundance of spun bearings.
|
Just reading that makes me cringe. You ever spun a rod bearing? Ever stick a piston? Yes and yes for me. =(
I just watched a show where they show how too much oil causes cavitation worse than with just a little less.
They say on some engines the recommended level is too high causing the crank to splash through the oil.
Causes drag and whips the oil into a foam.
With an engine on the dyno they took out a little oil at a time.
Each time oil pressure improved and hp went up.
The level they ended up at was well below what was recommended.