Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - AT ECU Reflash CAL-ID

DVision · 04-16-2020, 09:34 PM

Hey,

I've done a AT-MT CD00A Trans Swap.
Swapped all the harness etc.
The car is going to start if I press the brake and clutch pedal.

But i want to reflash the Ecu to a MT Software.
I've read here, that it is possible, the AT and MT ECUs are the same.

I use the Ecutek-Cable to flash with Tactrix.
How is it possible to change the CAL-ID of the ECU?
Or can i flash a different Base-Tune to the ECU with Tactrix?
Ecutek is present on my ECU, do I delete it with the Tactrix-reflash?

Thank You!

04-16-2020, 09:34 PM	#1
DVision Junior Member Join Date: Jan 2016 Drives: GT86 Location: Berlin Posts: 4 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	AT ECU Reflash CAL-ID Hey, I've done a AT-MT CD00A Trans Swap. Swapped all the harness etc. The car is going to start if I press the brake and clutch pedal. But i want to reflash the Ecu to a MT Software. I've read here, that it is possible, the AT and MT ECUs are the same. I use the Ecutek-Cable to flash with Tactrix. How is it possible to change the CAL-ID of the ECU? Or can i flash a different Base-Tune to the ECU with Tactrix? Ecutek is present on my ECU, do I delete it with the Tactrix-reflash? Thank You!