[Phoenix_gts86]

Hi guys as the thread title describes, this thread will be helpful to those who are interested in knowing just because and also for others who are planning to perform the same as myself.

I’m building my IAG Stage 1 12.5:1 CP rated to 550HP on my Manual
2013 Toyota gts86.

I have the following:
Have also attached an image of further parts that have been installed.
Tuned through Ecutek RaceRom Upgrade, no dynotune.
Garret Gtx2860RS (good for 360HP)
Aeroflow Turbo Blanket
Turbosmart IWG-75
Turbosmart Actuator GT28/60 7
Turbosmart BOV Plumb Black
AEM Boost solenoid, used to run Turbosmart WG Tee
K&N Pod Filter
Direct Clutch Stage 2
Lightweight flywheel with the clutch diameter custom made
AEM Tru Boost Gauge
4bar map sensor
Catless exhaust straight through with Invidia N1 catback and 1 Resonator
Cusco catch can
Ultrex Front Strut Bar

Potenza tires on the back 18” GT Hussle 18x8.5 5x95 +40, stockies on front

Parts I have but not fitted:
1200cc Port Injectors

Parts I haven’t bought yet:
Avo oil cooler
Walbro or DW Fuel Pump
Flex Fuel Kit

I am tuned through Ecutek with MRT Performance being the master tuner..

I may have forgotten one of two things but this is what I can think of at the top of my head so I suppose well go from there.
I have completed other mods but they’re aesthetic that aren’t performance supported.

Can you recommend what parts will be able to handle around 500hp for my 86 reliably as i’ve got the engine for it. She’s probably pushing 250-280hp currently but don’t know for sure.

For example,
-fuel pump
-fuel injectors
-rear axle
-oil cooler
-upgraded intercooler
-upgraded radiator?
-catch can
-Flex Fuel
-limitations to the manual gearbox?
-upgraded actuator?
-upgraded bov?

Can’t forget to say Thankyou in advance to all the future helpful replies.