View Single Post
Old 02-11-2020, 12:30 AM   #1
Kaily
Member
 
Kaily's Avatar
 
Join Date: Feb 2015
Drives: 2014 Hot Pink FR-S!
Location: Texas
Posts: 32
Thanks: 38
Thanked 11 Times in 8 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
My RPMs have been idling at 500

I've had my FRS since 2014 and my RPMs have always idled between 1000 and 2500 when I'm at a stop. Recently its been at 500 and the car shakes as if its about to stall.
I recently installed the Airlift 3p and installed new studs all the way around, with school and clinicals I didn't drive my car for about a week and a half while everything was slowly installed. Yesterday I took my car for a drive, I turned the car on and the ABS light was on, as well as check engine and traction lights. I disconnected the battery for about 10 minutes but nothing changed. I took it for a drive and the brakes felt normal. I couldn't get above 4000 RPMS in first and second gear. Autozone pulled the codes and the only one showing was the ABS sensor.
Then as I was in the Walmart parking lot, I came to a stop and the car just shut off. It turned back on without any trouble. Today I started the car up after going to visit my mom and it had a little bit of trouble starting, but that might be because it sat in the cold weather for a bit.
Does anyone have any words of wisdom or advice here? I'm not a pro at this stuff and I'm at a loss here. I don't want to drive my car to school in fear it'll stall again.
Kaily is offline   Reply With Quote
The Following User Says Thank You to Kaily For This Useful Post:
humfrz (02-11-2020)