View Single Post
Old 01-07-2020, 04:00 PM   #115
jflogerzi
Senior Member
 
jflogerzi's Avatar
 
Join Date: May 2012
Drives: 2013 Series 10 6MT FR-S
Location: Moreno Valley, CA
Posts: 5,565
Thanks: 2,013
Thanked 2,043 Times in 1,474 Posts
Mentioned: 72 Post(s)
Quote:
Originally Posted by Irace86.2.0 View Post
Today I got to a few things.

I readjusted my steering wheel one tooth counter clockwise, which seemed to align it straight. Then I used the Techstream and cable I got on eBay to clear the code that was tripping the Slip and ABS lights and then I performed a zero point calibration. After restarting the car the lights went away, and the cruise control and VSC Sport features worked again. I'll have to see in the ensuing days if the light stays off.

I also installed the genuine TRD wing. I removed the old wing by removing the four bolts and unclipping the five fasteners. Three of the bolts broke in the nuts, and I had to drill them out after I removed the wing. Whatever Locktite is on there was enough to prevent them from coming out, even with being careful. I cleaned the trunk then used a random action polisher to do a two stage polish to remove the dirt and oxidation on the lid. Then I measured for the holes using the templates, and I drilled the two required holes. Then







THAT @$$
__________________
2013 Series 10 FRS #553
RCE T2's, SPC LCAs -4/2.6 camber
JDL 4-2-1 EL, FP and OP, Tuned by Zach@CSG on e85
RR Wilwood Front/Rear Sport BBK, Motul 600 Fluid
ARC-8 17x9 SX2 GTs 245s/Koing 17x8 v730's 225's
jflogerzi is offline   Reply With Quote