[jbsali]

I bought a new Pioneer NEX Deck a few months back and noticed that the Deck goes through its usual phase: Backlight ON, Pioneer Logo, Loading Screen. Usually takes about 5 second or so to get through these.

This startup phase will happen flawlessly with both 12V and Accessory modes.

However, when I go to PUSH START my BRZ the phase experiences a drain or a complete power cut to the DECK when starting the ignition.

The Ignition startup phase goes Backlight ON, Pioneer Logo, Backlight OFF, Pioneer Logo, Loading Screen. Takes about 10-11 seconds to load all of these.

I couldn't find much info on it but I'm wondering if its an issue with source of power coming from the Ignition wire. I've thought about just wiring it to a 12V source but unsure if I would lose any kind of functionality. I also have a mono block amp and a subwoofer wired to the system.

Any help would be greatly appreciated.