|
Recommendations on an LED H1 hi/lo combo "bulb"?
So, after I realized I'd written down the wiring diagram wrong, I see that I'm getting 12V to both high and low, correctly, for both sides, as far as the car's harness.
The headlights, (or rather, the PO) are at fault. AND the bulb's wrong. Sheesh. What I have is the + and - for the low beams, hooked up to the single light. Which is not a hi/lo combo. Inside the light I see empty spade lugs on the side of the socket where I guess both the high and low should ground. Wires for high beam go into the light assembly, but are not visible at socket.
So, I need to open up the light assembly, ground both hi and lo, and then install an H1 LED combo. Right? Off base on that? Missing anything?
Many thanks;
Alan
|