Quote:
Originally Posted by Stang70Fastback
Nicely done, sir! Can't wait to receive my Trac-Box! The switch panel in my car, which is the original one I made by hand before turning to 3D printing for "mass production" is also made of clear acrylic - but covered with Alcantara instead of painted.
|
Yes, I followed your notes extensively. Thanks for the inspiration.
Getting that blasted piece out was not pleasant. I took half the interior apart trying to free it up. A lot of guides suggesting you should reach up behind the knee-pad trim piece and pop it out from behind, but there is zero chance of my hand fitting up there. Ultimately I shoved a trim removal tool under the cubby on the bottom right corner, while pushing down on the center console trim. That popped one clip loose and I was able to work my way along the bottom edge until the whole thing came out.