[black.86]

I have a set of USDM HID headlights from a Release Series FRS. I have read through all of the write ups I can find online and Im still a bit unsure about the DRL wire. I am installing these onto a base FRS w/ 6 pin connector. I am hoping someone with experience installing these can answer a few questions for me. Please note that I am a novice with wiring. I am wanting to achieve the “always on” LED strip without blinding people at night if possible.

1). Does the led+ wire (white LED wire) need to be completely removed from the headlight harness and spliced directly into the 12v wire that runs to the removed DRL resistor leaving only 5 wires actually connected in the headlight harness?? Or does the White led+ wire actually connect into pin 6 (parking+) and then the 12v wire gets tapped on the outside?

2). Is there a simple way to wire the USDM headlights for the LED strip to work as a DRL and stay on with low and high beam but at lower brightness?

3. Has anyone been able to utilize the diode dynamics always on module for this headlight swap?

If anyone has any clear pictures of the splice at the resistor box and the headlight harness that would be super helpful. Any help is greatly appreciated thank you in advance!