Quote:
Originally Posted by Bach415
@ Ced67 For some reason, just looking at your pictures looks like you are using the ECUTek version of the Flex Fuel kit. IIRC the OFT version for DT Flexfuel doesn't have a pass through for the O2 Sensor. It should only has a wire that goes straight to the ECU for the evap connection and another wire for power but I could be wrong. But what you are doing is also correct in order to get the proper reading for OFT. Just remember to figure out the voltage as Steve99 said in the previous post. |
@
Bach415 this is definitely not the ecutek kit. I had several in the hands and it has no passthrough. The ecutek kit goes right into the O2 connector (the sensor is deleted). It also has a third connector for the additional fuel pressure sensor.
I had some feedback thanks to my installator and it seems that it is a mistake from delicious when preparing the kit order. I gess they don't sell the oft one very often
Anyway, I had confirmation from them that my understanding of the wireing is correct: disconnect the grey wire from the O2 passthrugh and route it to the cpc.
EDIT:
I forgot to add, this is a 0.5-4.5V kit so I adapted the rom like this:
