[Mark Methods]

Originally Posted by theadmiral976

Here is the guide https://subaru.service-solutions.com...l.aspx?id=1306 (around $40 USD)

And here is the driver https://subaru.service-solutions.com...l.aspx?id=1305 (around $100 USD)

Not too terrible of a price for a specialty tool set. They really rip you off if you want the fuel pump ring installer - that ridiculous thing is a couple hundred for what amounts to a slightly enlarged oil filter wrench.

That is certainly an option.

I found one aftermarket manufacturer that describes their seal size which is accurate to what I was told by Joe @ ASF.

For the FA20:
SKF 36315A
Shaft Diameter 92 mm
Bore Diameter 109.5 mm
Outer Diameter 109.7 mm
Width 8.5 mm
Construction Type HMSA7





I will have to think on which tool set I'll order.


This generic one has the Toyota SST and will hold the crank which is nice.



https://www.ebay.com/itm/Master-Engi...AAAOSwXJhcvjzw


Thanks,
Mark