Quote:
Originally Posted by kev0
Just the black elbow connector was cracked. I replaced that.
I temporarily fixed the coupler leak but moving the metal clamp closer towards the front so it could seal the gap more. Going to try reverting to a base tune to see if that will fix it.
|
Did you clean off the “mating surfaces” of the inside of rubber coupler and outside intake pipe thoroughly before re-clamping? Any dirt, grime, gunk, sand etc.. can keep it from “sealing” properly.
How tight are you tightening the clamp? I generally tighten it so that the outside of the metal ring is pushing into the coupler just enough to make it flush with coupler. Not too much to damage it, but enough to thoroughly seal it.