I'm just going to piggy back off this thread. I just had mine installed a couple days ago. Ordered them through NigelJDM. I wanted to go higher so I also ordered a strut and multi-link spacer kit from Anderson Design & Fabrication:
https://andersondesign-fab.com/produ...-link-spacers/
I went with 1-1/2" in the front, 1-7/8" in the rear. We decided to not use camber bolts in the front because we could rotate the strut spacer to get 3 levels of camber. The multi link spacers were very important in the back to correct for camber in the rear. During the install we found the spacers had pushed the rear subframe too close to the exhaust. The shop tweaked the fitment and was able to get a 1/4 inch gap between the two. The exhaust is the Invidia Q300 with 2.5 inch tubing. And now the pics:
Before:
After:
