Quote:
Originally Posted by daftpunk
Damn, did you take pictures of this? Should be irrefutable evidence of it being their fault. It's not like you put that sealant in there lol
|
Yep, I did photo the mesh with bits, and the bearing.
Quote:
Originally Posted by ermax
Most wear on bearings comes from cold starts. I call bs on their theory. Avoiding redline, cold starts and low oil conditions saves bearings but most of all, avoiding blockage from sealant will save bearings.
|
It's my theory, not theirs. So far nobody admits anything, only finger pointing. I can elaborate more in the discussion thread.