Quote:
Originally Posted by EndlessAzure
Yes, you are describing the guides exactly. I've done that already, but it doesn't address my problem: My problem is not to get the LED Bar to work as DRL. My problem is to prevent the HiBeam reflector flap from actuating during DRL mode.
If, at any point, you run the "DRL Live" to ground via the resistor circuit, it will trigger the HiBeam reflector. This is because the resistor circuit appears to get its power straight from HiBeam GND
|
Quote:
Originally Posted by EndlessAzure
See Diagram 
I suppose something could be done if you tap from HiBeam source upstream of the connector |
I understand your problem, just trying to narrow down and make sure everything is plugged in correctly and tapped correctly. I usually like to confirm that everything is where it supposed to be before thinking of other possible problems that can cause it.
Which wire did you tapped into the DRL resistor? It should be the 12V+ DRL resistor wire that needs to be tapped (green wire I believe). If you tapped into the HiBeam GND near the DRL location, it might be the reason why it also causes the actuator to go off. Also make sure that the actual resistor is unplugged.
Another thing you can try is to untap that DRL live wire and make sure parking mode (beams & led strips off, side markers tail lights on) work properly as well low/high beam working properly. If so, then I would try connecting the DRL live wire to the fuse box (there should be a 12V connection in there but I am not sure. I've read about people tapping in there for other sources) and see if everything else still functions properly.