View Single Post
Old 05-02-2019, 12:29 PM   #27
demariners
demariners
 
Join Date: Jan 2015
Drives: 2015 Blue Subaru BRZ
Location: Gilbert, AZ
Posts: 42
Thanks: 0
Thanked 7 Times in 5 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Well re-pinning the clock spring is completely up to the installation. You can re pin it however you wish. The 2015 clock spring is only using 2 pins for the cruise control but the plug supports 12 pins. So you choose which ones you want to pin.

The steering wheel buttons have 5 wires (so you would choose 5 pins). Thy are typically parallel to the bottom of the clock spring. The 5 wires are Illumination -, illumination +, SW1 (Vol and Seek), SW2 (Phone, Source, Center Button), and SWG (feed). I do not know what wire is what as they are different depending on what button kit you get.

Other items you will need is the Airbag and all the parts that make up the steering wheel. I have posted below the part numbers I used. Also again you have to make a custom SW file with resistances.

Vol +/Phone Disconnect 1000ohm
Vol -/Center Button 3000ohm
Seek-/Source 330ohm
Seek+/Phone Connect 1ohm

Parts:
98211CA130VH - Airbag
34312CA150RG - Steering Wheel
34317CA040 - Steering Wheel Lower Piece
34318CA020 - Cap Cover Right
34318CA000 - Cap Cover Left
34327CA010 - Steering Wheel Damper
83154CA050 - Steering Wheel Trim/Buttons
demariners is offline   Reply With Quote
The Following 2 Users Say Thank You to demariners For This Useful Post:
CxG (06-27-2019), wolffbite (05-02-2019)