We are proud to announce a full PNP wiring solution for performing a Gen IV GM LS swap into the the Toyota 86, Scion FR-S or Subaru BRZ. All model years (2012-2019) are supported.
This kit was developed directly with Emtron USA.
This is a true PNP solution. Not a single wire needs to be cut to perform the installation of this kit. The harnesses are built using mil-spec Tefzel wire and Raychem DR-25 sleeving. Everything is built with new OEM connectors and terminals as a turnkey system.
- The kit includes a complete GM LS engine harness, interior Emtron KV8 jumper harness, alternator harness, engine ground harnesses, starter and transmission harnesses.
- The kit requires the use of an Emtron KV8 engine management system, which fully replaces the OEM 86 ECU.
- The Emtron KV8 offers full engine control and OEM CAN bus support.
- Key start and push button start vehicles are supported.
The full installation manual is attached to this thread.
Link to our Vendor classified section thread:
https://www.ft86club.com/forums/showthread.php?t=134417
Any questions? Just ask!