Quote:
Originally Posted by vijay.dy06
Will this have 100% compatibility and full canbus integration with the E40 LS2 pcm? I'm interested if it does.
Sent from my SM-G950U using Tapatalk
|
well this adapter will vary on its level of compatibility depending on your setup. Most of the limitations now in days are for the ECU your using on your swap. If you go with a LS3/E38 ecu.. alot more things will be fully compatible. And if you go with a order engine and you only have a tach wire and temp wire then alot less things will be compatible.
So im trying to make it as flexible as possible. the hardest part to make compatible would be the Torque request / commands since each car ecu is different, there is different gain patterns for it etc.. but besides that everything else is basically worked out. OH! speaking of gas pedal. I was also working on that too. i read in the voltages from the pedal and translate them over to the right levels for a Example LS3 ecu.
@
all4spl Im still looking for the OEM manufacturer of the plug. But havent had any luck. The only thing i can see is that iWire sells the plus and pins for 100dlls.
oh and @
vijay.dy06 i when over to there website and i see they dont sell nothing like that. Nor do i see any post of that in this forum either. So were do they sell it at? Not sure when they did that.