Quote:
Originally Posted by Ultramaroon
I've considered that but the stuff sets up pretty quickly. I think the parts have to be assembled within five minutes of application.
|
The manual says to bolt within 5 mins but to not add oil or crank for 30mins.
When I was finished doing all my packing I still had some left in the tube but I threw it in the trash because I’ve never had luck sealing up tubes like this anyways. But the next day out of curiosity I pulled it out of the trash and it was only hardened about 5mm up the nozzle. After clearing the nozzle the consistency of the sealant that was left in the tube seemed perfectly fine. I checked back again days later and again it wasn’t harden more than 5mm or so. Most sealants I’ve used the entire nozzle will harden and then travel into the tube making the whole tube useless after sitting just one night.