[geraldjust]

Hey guys! Ive been working on a recent project and i might want you guys input on were i should go with this.

So ive been this is all in one PCB with a micro controller and can bus integration.
Im using it so sniff the factory data though the canbus and displaying it vs other generic gauges who just use OBD protocol to poll for data that can cause some issues though the network if polled too quickly. Anyways! So i get some generic data though the network like RPM, Speed, Oil temp, water temp, gear, accel pedal, break pedal, individual wheel speed, G-meter, Steering wheel angle, ambient temp, MAP sensor, battery temp, battery current sensor, fuel level...

Along that i can also sniff other non "live data" like doors open /closed, locked or unlocked. same with trunk. clutch, reverse, headlights on/off. dimmer switch position, parking break, low beams high beams, seatbelts for both RH and LH..

For push start cars errors like if you leave your key in the car and close the door when car is off and you trying to lock from outside. If key is not detected in vehicle message. If your key has low battery then to press the clutch and touch key to start button message...

And besides those.. i Have some special function i added. Like Speed Auto lock. when your driving if you go above a certain speed your doors auto lock and if below the speed it auto unlocks when pulling up the handbrake.

I also have A nanny long press a button to turn off/on. so no need for peddle dance. Just make sure your car is semi warm and RPM below 1k.

Il add also something for forcing fans on to 100% for those people in the track? if people want it.

For now thats it for the hardware but i might make a add-on or Bluetooth in the future.

So i was wondering how you guys think i should structure it for the menu system etc....

So basically if i have it wired were power is applied to ig+ then i could make it like a simple gauge showing data and some active stuff like auto lock and nanny control.

But my second idea was to have it always on. When the car goes to sleep data wize have the gauge also sleep. but when someone opens the door. or unlocks it to wake up and have a "press clutch and start button to run" or simple things like that. Or show if you left your trunk open or doors when the car is off.

SO if you got any suggestions on how i should make the menu system or what extra features i should add.

[ame="https://www.youtube.com/watch?v=mbimdasDgKE"]https://www.youtube.com/watch?v=mbimdasDgKE[/ame]