Quote:
Originally Posted by steve99
Easier way to achieve 100% di till 0.6 load is jist to put zero in the cells up to 0.6 load in all three pi\di tables clod warm hot
Some bigger port injectprs are not good at injecting small quantities of fuel at low pulse widths. As we have a dual injection system when your injecting from both systems pulse widths are even smaller. By going to 100% di at low loads your jist using the standard factory direct injectors which have suffient capacity at low loads to supply all fuel. Then switch in the port as fuel demand increases and longer pulse widths required
|
so we are on the same page you are talking about the "Total Injection Ratio Port cold/warm/hot" tables?