So we did end up going to the wind tunnel to correlate our CFD data to what is seen in the real world. We are still going through the data recorded at the tunnel as it just happened a few days ago, but when we have the data to share we will share it! In the meantime here are some photos.
The carbon unit is our 300mm chord single element unit which we already produce. This is the same profile used in our FRS/BRZ wing; the FRS/BRZ wing is a 3D shaped wing though vs. this unit being a 2d profile.
The 3D printed unit is possibly the 250mm chord that we may bring to market down the road.
Both profiles were developed by us and are our own profiles.
Thanks,
Eric