[CokeZero]

Well to start off, I bought a 2015 Subaru BRZ Series Blue. It's a flood car and my intention is around a 700hp ls2 street build. But for now I'm just trying to get the car back going like factory before I swap it.

The previous owner replaced the computers due to the flood but some things still aren't working.

The cluster doesn't come on. The car will not go into accessory mode or run or start. The hazard indicators flash in the cluster when their on.

The cluster, the clock, the radio, the power windows, the heated seats all do not work.

The lights, interior lights, horn, hazards all work fine. The car just won't turn on. (The obd port does get power too)

Ive replaced all 3 ecms, checked all fuses, made sure the battery was good, tried holding key to start button, nothing is working.

[ame]https://www.youtube.com/watch?v=M5KOtsy0Zfg[/ame]

The obd 2 port does work. when I put a dongle on there it lights up. But I thought you had to be in the "on" position to be able to program anything.

In this pic #1, #6 and #7 were replaced.

Would them not being programmed cause the cluster not to light up? I assumed it still would. maybe even turn over, just not start. But the previous owner told me its because all the computers need to be programmed that's causing this.

The Toyota dealership in my town said they can't reprogram mine that only a Subaru dealership can (which i don't have in my town)

I've checked all the fuses and swapped around some relays. I've put the original computers back in and switched out every combination of the three.

Kind of clueless where to go from here. I don't wanna take it to the dealer for program and them tell me something else is wrong and charge me anyway