|
p0014+p000b
Just wanted to chime on this thread.
I have a MY13 BRZ about 67k... got it used, pretty cheap
has p0014+p000b code.
followed the TSBs posted in the sticky:
Purchased new OCV and replaced old one on bank1 exh: code persisted
Swapped OCV to opposite position, ran Test Mode B: code persisted
Purchased new CAM Sprocket for exh bank1, replaced old: code persisted
ran OFT to clear codes, loaded a stage 1 tune (for s$%ts and giggles): code persisted
flashed back to original: code still comes up
I am running RP 0w20, not sure if maybe this is the cause... was going to go this route prior to hunting down a new ECU.
anyone have any new developments on these codes? really annoying
|