[Target70]

Originally Posted by vfrqqq

I'll bust out the real camera to get different angles and a better depth of focus.

It's a little dark to tell, but is that small black wire that is exiting the box over the top right screw hole for the cover attached to anything?

If it isn't that loose wire, and is a burnt component, most likely to fix it will require you to to remove the cca's from the box. again can't tell from the pic, but all I can see is that one screw holding the voltage regulators against the heat sink on the right (with all the white thermal paste). If nothing else, it looks like those two large black wires on the left side are blade terminals that you might be able to disconnect to get a better view.

Hopefully If you can free the cca's from the box, you should be able to just slide the wiring harness back through the grommet to let the cards come out of the box without desoldering anything.