|
Need to remove the wheels to do all the installs. On the front guard. Remove 3 push pins and the one underneath. Pull back wheel well cover and you will see the 3 holes where the push pins were in. Use the 2 clips and slide them in between the holes. Slide 1 on the middle hole and slide one bottom. Now place back the wheel well cover and put the mud guard in place. Line up the holes. Use the old push pin for the top hole. Use the 2 new screws in the middle and bottom holes. Now use the new large push pin in the hole that faces down on the bottom of the guard. Last you will need to drill hole. You will see the pre drilled hole in the guard. use that as a guide to drill into the wheel well cover. After that is done use the small push pin and your finished. You can go to the any scion parts dept. and they can print you out the instructions.
|