This is how the 86Nanny is sitting under the steering column.
Beat the shit out of the metal plate including flattening out the outer edge so that the Nanny can be bolted and put some extra washers on one side so that there is not too much stress on the plastic edges, and everything just fits.
The last picture shows the steering wheel in the lowest position, there is no interference whatsoever. The only thing to figure out is where to place the OBDII port extension.
I hope this installation completes my list of mods for the time being. At some point I want to put in aftermarket seats and a 4-point roll bar/half-cage and install the OS Giken/rear diff and subframe bushings but I want to take a break from further mods for a while and switch my focus to other car projects that I left unfinished in the midst of prepping the BRZ for track duty.
