[gtpvette]

Sway bar work continues. I was sure the OEM bar would work after test fitting. Well,, rubs a bit on the cross member right in the front corner. May be able to grind a bit off,,, but it'll be tight if so. If no go it's back to a speedway bar.

The mounts are for 1" sway bar so moving back to a speedway bar should be OK. As a sidebar,, added a piece of 1" pipe drilled out to 18 MM to sway bar as a spacer.

Also,,, the mounts are a bit more inboard than I would of liked. I did that so there was enough to weld the mounts to and as you move out on the cross member it get pretty thin.

The end links will need to be shortened or replace with shorter one.